EZ-Stick.  .  .  for synthetic substrates

This new process offers superior performance for less cost than expensive PSA and transfer tapes.  Available in either a Low Tack Removable or Permanent Adhesive.

 

Ideal for:  Window Graphics ∼ Cooler Units ∼
POP Displays ∼ Mouse Pads ∼ Decorative Decals
. . . and much more.

 

KEY FEATURE

EZ-Stick eliminates the need for expensive backer films, flood coating and reverse printing.  This process enables you to produce two way signage for significantly less cost and, eliminates the need for extra press runs.

EZ-Stick can be applied to a wide variety of substrates, allowing printers a greater choice of stocks.  The opposite side can also be finished with a Write & Wipe film for use with dry or wet erase markers.

EZ-Stick can be applied to:

>Sheet sizes from 12″ x 18″ up to 42″ x 81″
>Stock thickness:  6 mil to 100 mil including foam board
>Plastics such as vinyl, styrene, PETG, synthetic papers & more
>Sheet layout must allow 1″ gripper on all sides
>Working loss is approximately 5%

EZ-Stick Low Tack                                           EZ-Stick Permanent
Easy mounting and removes                     Easy mounting to glass for
cleanly from glass.  Repositionable        a stronger more permanent
during the installation process.                bond.
Excellent clarity.                                               Good durability.

Installation:  Product must be applied to a clean, dry and dirt/contamination free surface.  Firm pressure must be applied to increase the cold flow and contact of the adhesive with the substrate.  Time and temperature will increase the surface contact and adhesion values.  Low Tack is not removable from acrylic surfaces.

EZ-Stick sheets must be packed and shipped FLAT for successful installation.
NEVER roll, tube or ship sheets in any other manner.
NOT INTENDED FOR WALLS

Purchaser shall use all information, recommendations and suggestions contained herein only as a guide.  The information does not constitute a warranty nor guarantee of any type whatsoever.  Purchaser should independently determine the suitability of all material and must confirm adaptability and other characteristics by conducting its own tests.  Piedmont Laminating & Coatings shall have no liability as a result of any loss, expense, damage, and cost; or other injury, which results from Purchaser’s reliance on the information.